• Registered: 2018-12-16
  • Posts: 346

Topic: Walk Forward and Monte Carlo Question

Hi,

on Reactor there under Walk Forward validation i can set the segments oos and valid segments than there is written "This tool uses settings from Walk Forward" . The same on Monte Carlo.

When i now go to Walk Forward than i have other settings than i have switched before. What did the Walk Forward now use. The settings from Reactor or the settings from Walk Forward in the options? The same Monte Carlo.

  • Popov
  • Popov
  • Lead Developer
  • Offline
  • From: Bulgaria
  • Registered: 2006-11-30
  • Posts: 8,014

Re: Walk Forward and Monte Carlo Question

The settings in the Reactor overrides the corresponding settings of the separate tool pages. The settings that are not shown in the Reactor are taken from the tool pages.

Popov's Website