Forex Software — Closing logic conditions are not working with bar, daily or weekly

Re: Closing logic conditions are not working with bar, daily or weekly

2020-05-02T13:23:44Z

That's done it. Great, thanks. What a brilliant piece of software this is & your support is top notch.

Re: Closing logic conditions are not working with bar, daily or weekly

2020-05-02T13:13:55Z

The bar on the Screenshot is at 10:00. If you use it with Day Closing indicator, the signal for closing must be at 24:00.

The selected closing condition will work every time if you use Bar Closing for Closing point of the position.

Re: Closing logic conditions are not working with bar, daily or weekly

2020-05-02T12:09:32Z

Thanks for your quick response. Please see attached chart. It should close when the CCI crosses down below 120 & the panel on the right says YES to close out long position, which I have highlighted in yellow.

However, you can see that the position stays open.

Re: Closing logic conditions are not working with bar, daily or weekly

2020-05-02T11:15:36Z

What exactly?

Post a detailed screenshot of your strat and explain where it is not working.

Closing logic conditions are not working with bar, daily or weekly

2020-05-02T10:42:28Z

I cannot make Closing logic conditions work with bar, daily or weekly condition. It will close the trade but not as it should. If I close it using the standard close logic conditions it will work fine. However, if I tray to add CCI or RSI to the Weekly or Daily closing condition then it does not behave correctly.

If CCI or RSI was added as a standard closing condition from the dropdown list then that would help & I would happily pay for a subscription. At the moment though I cannot get it to work properly, any ideas?