Forex Software — High & Low?

Re: High & Low?

2015-06-25T23:16:58Z

Thanks alot for the help!

Regards,
Halvard

Re: High & Low?

2015-06-25T23:13:59Z

The concrete answer to your question is NO, the Generator will not use the Commodity Chanel Index in a closing logic slot.

You have linked the Closing Point indicator, which is different than Bar Closing. The Generator will not be able to set Bar Closing and therefore, it will not be able to use Closing Logic Conditions.

Re: High & Low?

2015-06-25T23:08:41Z

The picture shows that you have disabled indicators for the Closing Logic Conditions slots. It is not clear what exactly you are asking for.

Link - the Generator will use the indicator without being able to remove it but it will be able to change its parameters

If there are unoccupied slots, the Generator will put some of the enabled indicators. If there are no enabled indicators, you'll not be able to run the Generator.

Re: High & Low?

2015-06-25T23:05:59Z

I agree the wording could be better, I had to re-read it too to see if it answers your question, and yes, it answers your question.

(If you) Link - the Generator will use the indicator without being able to remove it. You see now? If you link an indi in the gen, it will not remove but change the parameters of the indi, banning or sorting the indis on your left pic is out of question here. If you link the indis in all usable slots, then it sure as hell will only use those indis, otherwise we would have a major bug.

Hope this clarifies your question!

Re: High & Low?

2015-06-25T22:56:21Z

That was not what I was asking . I was wondering if it still will use the indicators
in the left side (On picture). Reason I ask, is because I cant see them in the strategies in the
repository, it seems like it only uses the linked indicators.

Regards,
Halvard

Re: High & Low?

2015-06-25T22:41:06Z

halvardu wrote:

Thanks alot, it's working now )
I now have another question..hehe. Take a look at the picture below, I have a couple of questions
there.

Thanks for all the help!!
Halvard

Lets see what the manual says:

Manual wrote:

Link - the Generator will use the indicator without being able to remove it but it will be able to change its parameters

Re: High & Low?

2015-06-25T22:33:39Z

Thanks alot, it's working now )

I now have another question..hehe. Take a look at the picture below, I have a couple of questions
there.

Thanks for all the help!!
Halvard

Re: High & Low?

2015-06-25T20:48:39Z

Here is an example:

[Opening Point of the Position]
Moving Average
Enter the market at Moving Average
...

[Opening Logic Condition]
Previous High Low
The position opens above the previous high
Base price - High and Low
Vertical shift - 10

We open a position at MA only if the MA at the moment of opening is higher than previous bar High + 10 points.

And we enter short at MA when the MA (position opening price) is lower than previous Low - 10 points.

High & Low?

2015-06-25T20:17:38Z

Hi, can anyone please show me how to use high and low in FSB? Just a little example
on how to enter a trade when, lets say: current close is higher than the to last candles high, or the current close is higher than the last highest high.

Just point me in the right direction

Thanks in advance!
Halvard